Notes
15
5.13 Program Example 1
The following sequence of entries creates and runs the program shown graphically below.
1. Turn the controller SP down to ‘0’ by pressing down .
2. Press page until Prog, Segments Used is displayed. On P10 or P25 models press
up or down to select a new program number, (a program with only 1 segment).
3. Press scroll until Holdback Value is displayed. Default ‘0’ degrees.
4. Press scroll until Ramp Units is displayed. Press up or down to set to ‘Min’
5. Press scroll until Cycles is displayed. Default ‘1’
6. Press scroll until Segment 1 is displayed
7. Press scroll until Segment Type is displayed. Press up or down to select
‘Rate’
8. Press scroll until Holdback Type is displayed. Default ‘Off’
9. Press scroll until Target SP is displayed. Press up or down to set to ‘400’
degrees.
10. Press scroll until Ramp Rate is displayed. Press up or down to set to ‘5.0’
degrees per minute.
Repeat steps 6 to 10 for 4 more segments. Set Holdback to the default ‘Off’. Enter the
following parameters and values:
Segment Type Dwell Duration ‘30:00.0’ minutes
Segment Type Step Target SP ‘600’ degrees
Segment Type Dwell Duration ‘30:00.0’ minutes
Segment Type Time Target SP ‘200’ degrees, Duration ‘2:00:0’ hours
Finish the program with an End segment:
11. Press scroll until Segment Type is displayed. Press up or down to select
‘End’
12. Press scroll until End Type is displayed. Press up or down to select ‘Reset’
13. Press page and scroll together to return to the home display.
To run the program either press RUN/HOLD or:
14. Press page until Program Status is displayed
15. Press scroll until the cursor moves to the program status of ‘Reset’
16. Press to select ‘Run’.
Segment 1
Type ‘Rate’
Target 400°
Rate 5.0°/Min
Segment 2
Type ‘Dwell’
Duration
30min
Segment 3
Type ‘Step’
Target 600°
Segment 4
Type ‘Dwell’
Duration
30min
Segment 5
Type ‘Time’
Target 200°
Time 2 hours
Segment 6
Type ‘End’
End type
‘Reset’
Time display examples
10:05.3 Min / Sec / 10
th
Sec
24:10:05 Hour / Min / Sec
196:10 Hour / Min
Comments to this Manuals