Carbolite 3508 User Manual download pdf (Page 8)

Basic Operation

8 MC19-1.20

4 Setting up the controller

Before using the controller (or during its lifetime) certain parameters may have to be set,

depending on specific requirements. To do this the Controller must be set to supervisor

Level 2, see section 3.5.

4.1 Maximum output power setting

Press page  until Control Output Hi is displayed. Press up  or down  to adjust the

value.

Depending on the furnace or oven model, the maximum power output setting may be

accessible or locked.

For Silicon Carbide heated furnaces the parameter is accessible to allow compensation for

element ageing. Refer to the product manual for details.

In many models the maximum power output setting depends on the supply voltage, refer to

the product manual for details.

4.2 Customer ID.

A furnace or oven identity number can be entered if required. This may be used to identify

one of many units, for production or quality control systems.

Press page  until Customer Identity is displayed. Press up  or down  to select a

number.

4.3 Units

Press page  until Units is displayed. Press up  or down  to select:

C Celsius

F Fahrenheit

K Kelvin

4.4 Language

The text on the 3508 can be shown in different languages, this can only be set at the factory

and therefore must be specified at the time of placing an order.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

Carbolite 3508 User Manual Page 8