Carbolite 3508 User Manual download pdf (Page 11)

Notes

MC19-1.20

Program number

On P10 or P25 models press up  or down  to select a new program number. The

display will show that new programs have only one segment.

Holdback Value

Press scroll  until the display shows “Holdback Value”. If required: Press up  or down 

to set a value. This value will be used in any segment where a Holdback Type is set.

Ramp Units

These apply to Rate segments only. Press scroll  until the display shows “Ramp Units”.

Press up  or down  to select the ramp units of degrees per Hour, Min or Sec.

Number of program cycles

Press scroll  until the display shows “Cycles”. Press up  or down  to select more than

one cycle.

Now create all the segments for your program, finishing with an End segment. When

parameters for each segment have been entered the display goes to the next segment

number.

Segment Type

Press scroll  until the display shows “Segment Type”. Press up  or down  to select

Rate, Time, Dwell, Step, Wait, GoBack, Call or End.

Holdback Type

Press scroll  until the display shows “Holdback Type”. If required, press up  or down 

to select Off, Low, High or Band.

Target Setpoint (Visible only for Rate, Time and Step segments)

Press scroll  until the display shows “Target SP”. Press up  or down  to set a value.

Ramp Rate (Visible only for Rate segments)

Press scroll  until the display shows “Ramp Rate”. Press up  or down  to set the

number of degrees per Ramp Unit as set above.

Duration (Visible only for Time and Dwell segments)

Press scroll  until the display shows “Duration”. Press up  or down  to set a value.

Wait For (Visible only for Wait segments)

Press scroll  until the display shows “Wait For”. Press up  or down  to select:

PrgIn1, PrgIn2, PrgIn1In2, PrgIn1orIn2, PVWaitIP.

GoBack to segment number (visible only for GoBack segments)

Press scroll  until the display shows “GoBack Seg”. Press down  to select a segment

number to go back to.

GoBack Cycles (visible only for GoBack segments)

Press scroll  until the display shows “GoBack Cycles”. Press up  or down  to set a

value.

Call Cycles (Visible only for call segments)

Press scroll  until the display shows “Call Cycles”. Press up  or down  to set a value.

End Type (Visible only for End segments)

Press scroll  until the display shows “End Type”. Press up  or down  to select Reset,

Dwell or SafeOp.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments

Carbolite 3508 User Manual Page 11

Comments to this Manuals

Related products and manuals for Control panel Carbolite 3508