Carbolite, Parsons Lane, Hope,
Hope Valley, S33 6RB, England.
Telephone: +44 (0)1433 620011
Fax: +44 (0)1433 621198
E-mail: info@carbolite.com
The products covered in this manual are only a small part of the wide range of
ovens, chamber furnaces and tube furnaces manufactured by Carbolite for
laboratory and industrial use. For further details of our standard or custom built
products please contact us at the address below, or ask your nearest stockist.
Copyright © 2014 Carbolite Limited
For preventive maintenance, repair and calibration of all Furnace
and Oven products, please contact:
Carbolite Engineering Services
Telephone: +44 (0)1433 624242
Fax: +44 (0)1433 624243
9.0 SPECIFICATIONS
Carbolite reserves the right to change specifications without notice.
9.1 Models Covered by this Manual
3-zone Split Tube furnaces heated by resistance wire moulded in refractory fibre
Horizontal Models in an opening case
Vertical Models with a variety of stand and fixing options
Models above have end zones of 150mm unless specially ordered.
Models with suffix E have equal zones (3 x 200mm or 3 x 300mm)
Also models based on the above, but of other lengths, supplied to special order.
note 1: The figures for uniform zone length are for ±5°C and are based on
measurements with the furnace horizontal and fitted with insulating plugs in both tube
ends. They assume the use of master-slave control.
note 2: Weights are approximate for horizontal models and do not include fittings
or vertical stands.
9.2 Environment
The furnaces contain electrical parts and should be stored and used in indoor conditions as
follows:
maximum 80% up to 31°C decreasing linearly to 50% at 40°C
Comments to this Manuals